Analog Camera Module can be ordered along with any Apalis or Colibri module and carrier board.
All the products can be ordered online at Toradex Webshop
Please read the following articles before using this product.
Please contact our technical support. Various option of technical support are mentioned in the article below.
- Uses MAX9526 decoder by default (ADV7180 decoder as assembly option)
- Analogue Input: 5 multiplexed video input channels, supporting NTSC or PAL composite video signals
- Parallel data output format:
8-Bit Parallel ITU-R BT.656 with optional separate horizontal and vertical syncs
- No external power supply required
With default assembly option, MAX9526 decoder is enabled. In order to use ADV7180 decoder, 5 zero ohm resistors need to be changed using manual soldering process.
Please refer Analogue Camera Module Datasheet, Section 4 (Assembly Options) for more details.
Connector X1 of the Analogue Camera Module V1.1 is 1:1 pin mapped with respect to the connector X22 on the Colibri Evaluation board V3.1. A 24 way 1:1 IDC ribbon cable connector can be used to make connection between the two boards.
On Colibri Evaluation board V3.2, connector X22 pinout has been updated in order to maintain the compatibility with the Apalis Evaluation Board. So a custom connector will be required in order to connect the ACM V1.1 with the Colibri Evaluation Baord V3.2.
Also a custom connector will be required to connect the ACM V1.1 with the Ixora Carrier Board.
On Apalis Evaluation board, few jumper settings need to be changed, if you are trying to connect the ACM V1.1 using 1:1 IDC flat ribbon cable connector.
Please refer Analogue Camera Module Datasheet, Section 6 (Pin Mapping) for more details.
||Changes from Previous Version
Analogue Camera ModuleV1.1A